Ramsey-winch RPH-30000T-117 Bedienungsanleitung

OPERATING, SERVICE AND MAINTENANCE MANUALMODEL RPH-30000T-117INDUSTRIAL PLANETARY WINCHIntended Purpose: Vehicle Recovery and Pulling of Loads

6. Pull drum assembly (item #1) upward from end bearing (item #10). Remove quad-rings (item #60& #61) from grooves in drum bushings. Remove inp

7. Remove output coupling (item #8) and coupling shaft (item #7) from end bearing (item #10).Examine bearings (item #17), pressed in output coupling

9. NOTE: DETERMINE MOUNTING CONFIGURATION OF WINCH (R.H. or L.H. MOUNTED) BEFORE ATTACHINGUPRIGHT FRAME TO WINCH, TO ASSURE PARTS ARE MOUNTED TO PROPE

11. Apply RTV sealing compound to ring gear mounting surface of end bearing (item #10). Placering gear onto end bearing, aligning holes in ring gear

13. With pin (item #66) installed in coupling, align splines of coupling (item #9) with splines of input shaft below. Slidecoupling over end of shaf

15. Apply Permatex to threads of plug (item #65). Thread plug into tapped hole in bottom of gear housing endbearing (item #10). Pour approx. 2.50 pint

OPERATIONAdjust the free-spool effort of the cable tensioner. Disengage the winch clutch and free spool some cable offthe drum. Adjust the air pressur

151.052 SAE STRAIGHTTHREAD O-RING PORT(TYP 2 PLACESOPPOSITE SIDES)9/16-18 O-RING CASE DRAIN PORT

16

1 1 234183 DRUM ASSY.2 1 242165 ASSY-FRAME, WINCH MTG3 1 265021 TENSIONER-LEVER4 1 296433 GEAR BOX ASSY.5 1 300069 ADAPTER-AIR CYLINDER.6 1 304172 BAR

TABLE OF CONTENTSINTRODUCTION...

RAMSEY WINCH COMPANYPost Office Box 581510 Tulsa, Oklahoma 74158-1510Telephone: (918) 438-2760 FAX: (918) 438-6688OM-914008-0503-HLIMITED WARRANTYRA

RAMSEY HYDRAULIC PLANETARY WINCH MODEL RPH 30000T-117PLEASE READ THIS MANUAL CAREFULLYThis manual contains useful ideas in obtaining the most efficie

WINCH FRAME MOUNTINGUse (8) 5/8 inch diameter grade 5 or better bolts to attach mounting frame to wrecker.CABLE INSTALLATION / TENSIONER OPERATIONCAUT

PERFORMANCE CHARTS CLUTCH OPERATION 1. Move the clutch control valve to the "clutch-engaged" position. 2. Anytime the te

MAINTENANCEAdhering to the following maintenance schedule will keep your winch in top condition and performing as it should with a minimum of repair.A

INSTRUCTIONS FOR OVERHAUL1. Remove wire rope from winch. Disconnect hydraulic, air and electric lines. Remove winch andframe from vehicle mounting.

2. Drain oil from gear housing (item #10) by removing plug (item #65) from end bearing. Removereducer and relief fitting (items #63 & #57).If ne

4. Remove brake assembly screws (item #28) from brake (item #53) and end bearing (item #11).CAUTION: Brake is spring loaded by clutch spring and must