OPERATING SERVICE AND MAINTENANCE MANUAL MODEL HDG 350 RAM-LOK® INDUSTRIAL LOW-MOUNT (MFG. PER JERR-DAN SPECS.) CAUTION: RE
8 9. Examine shifter assembly (item #2) for damage to yoke. Yoke should be firmly attached to shaft, yet able to swivel freely around shaft. Replace
9 13. Press bearing (item #14) onto worm and into housing. NOTE: Be sure that thick shoulder of bearings outer race (side with manufacturer's
10 15. Place thrust washer (item #46) over end of drum shaft and slide downward until spacer rests on drum. Press drum downward to compress springs
11 ADJUSTING THE OIL COOLED WORM BRAKE The oil-cooled, fully adjustable, automatic brake operates in the worm housing lubricant, all parts being sub
12 SERVICING OF THE OIL COOLED BRAKE 1. Back off the lock nut, then the adjusting screw, both two turns or more by turning them counter-clockwise.
13 RE-ASSEMBLING AND CHECKING THE BRAKE 1. Press brake hub into place over worm shaft and key. 2. Assemble balls into #1 slots of cam. Use stiff g
14 11.31®MODEL HDG-350 RAM-LOK4.00.44 DIA WIRE ROPE.50 DIA HOLE FOR6.355.136.87(REF)12.442.123.633.716.21#242170FRAME ASSEMBLY1.123.50 DIA.7.25 DIA.1
15 CAPSCREW 3/8-16NC X 1-1/2" HX HD GR 5 ALL-THRD241815411211711611311411514111486070494007442189474001486069110111107108104105106101102ITEM NO
17 PARTS LIST MODEL HDG-350 ITEM QTY PART DESCRIPTION ITEM QTY PART DESCRIPTION 1 1 242170 FRAME ASSEMBLY 25 8 418177 LOCKWASHER 3/8
TABLE OF CONTENTS INTRODUCTION ... 1 WARRANTY INFORMATION...
18 LIMITED WARRANTY RAMSEY WINCH COMPANY Post Office Box 581510 Tulsa, Oklahoma 74158-1510 Telephone: (918) 438-2760 FAX: (918) 438-6688 Vis
1 RAMSEY WINCH MODEL HDG-350 RAM-LOK® PLEASE READ THIS MANUAL CAREFULLY: This manual contains useful ideas in obtaining the most efficient operation
2 TECHNIQUES OF OPERATION The best way to get acquainted with how your winch operates is to make test runs before you actually use it. Plan your tes
3 WINCH MAINTENANCE Adhering to the following maintenance schedule will keep your winch in top condition and performing as it should with a minimum o
4 HYDRAULIC SYSTEMS Refer to performance charts, below, to properly match your hydraulic system to the HDG-350 winch performance. The charts consis
5 TROUBLE SHOOTING GUIDE INSTRUCTIONS FOR OVERHAUL OF HDG-350 DIS-ASSEMBLY 1. Drain oil from gear housing by removing (item #36) plug from bottom
6 2. Remove clutch housing (item #9) and clutch (item #5) from winch assembly. Remove two keys (item #31) from keyways. A screwdriver can be use
7 5. Remove gear housing cover (item #6) from gear housing (item #10) by unscrewing capscrews (item #18). Thread two of the capscrews into the two
Kommentare zu diesen Handbüchern