Ramsey-winch RPH-25000 (JERR-DAN) Bedienungsanleitung

OPERATING SERVICE ANDMAINTENANCE MANUALMODEL RPH 25,000 INDUSTRIALPLANETARY WINCHPER JERR-DAN SPECIFICATIONSCAUTION: READ AND UNDERSTAND THIS MANUAL B

6. Pull drum assembly (item #1) upward from end bearing (item #14). Remove quad-rings(item #63 & #62) from grooves in drum bushings. Remove in

7. Remove output coupling (item #12) and coupling shaft (item #10) from end bearing (item#14). Examine bearings (item #21), pressed in output coupling

9. NOTE: DETERMINE MOUNTING CONFIGURATION OF WINCH (R.H. or L.H. MOUNTED)BEFORE ATTACHING FRONT AND REAR FRAME ASSEMBLY TO WINCH, TO ASSUREPARTS ARE M

11. Place (2) gear carrier assemblies into ring gear meshing carrier gears with ring gear. Makesure that ring gear and carrier assemblies are securel

13. With pin (item #69) installed in coupling, slide coupling (item #11) over end of input shaftbelow. Slide coupling over end of shaft (item #16).

15. Apply Permatex to threads of pipe cap (item #68). Thread pipe cap onto pipe nipple inbottom of gear housing end bearing (item #13). Pour approx.

WINCH MOUNTING CONFIGURATIONSL.H. MOUNTING CONFIGURATIONR.H. MOUNTING CONFIGURATIONANGLE SIDEANGLE SIDE14

RPH 25,000 L.H. (123508)15

RPH 25,000 L.H. (123508)16

17

TABLE OF CONTENTSINTRODUCTION . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1WARRANTY INFORMATION . . . . . .

RPH 25000 PER JERR DAN SPECIFICATIONS18

ITEM QTY PART NO. DESCRIPTION ITEM QTY PART NO. DESCRIPTION1 1 234182 DRUM ASSY. 36 1 416051 SETSCREW 5/16-24 NF X 1 LG SOC HD CUP2 1 242164 ASSY-FRAM

LIMITED WARRANTYRAMSEY WINCH warrants each new RAMSEY WINCH to be free from defectsin material and workmanship for a period of one (1) year from date

RAMSEY HYDRAULIC PLANETARY WINCH MODEL RPH 25,000PLEASE READ THIS MANUAL CAREFULLYThis manual contains useful ideas in obtaining the most efficient op

WINCH ANGLE MOUNTINGUse (8) 5/8" diameter grade 5 or better bolts to attach mounting angles to the wrecker.CABLE INSTALLATION / TENSIONER OPERATI

Refer to the performance charts to properly match your hydraulic system to RPH-25000 winch perform-ance. The charts consist of:(1) Line pull (lb.) fi

MAINTENANCEAdhering to the following maintenance schedule will keep your winch in top condition and per-forming as it should with a minimum of repair.

INSTRUCTIONS FOR OVERHAUL1. Remove wire rope from winch. Disconnect hydraulic and air lines. Remove winch andframe from vehicle mounting.Remove (2)

2. Drain oil from gear housing (item #14) by removing pipe cap (item #68) from pipe nip-ple in end bearing. Remove reducer and relief fitting (items

4. Remove brake assembly (item #55) by removing (2) mounting screws (item #33) attach-ing brake to end bearing (item #13). Remove coupling (item #11)