Ramsey-winch PATRIOT 15000 Bedienungsanleitung PDF herunterladen (Seite 2)

Safety Precautions To Guard

Against Possible Injury.....

A minimum of five wraps of cable around

the drum barrel is necessary to hold the

rated load. Cable clamp is not designed to

hold the load.

A. Keep yourself and others a safe distance to the side

of the cable when pulling under load.

B. Do not step over a cable, or near a cable under load.

C. Use supplied hook strap when handling hook for

spooling wire rope.

D. Do not move the vehicle to pull a load on the winch

cable. This could result in cable breakage and/or

winch damage

E. Use a heavy rag or gloves to protect hands from

burrs when handling winch cable.

F. Apply blocks to wheels when vehicle is on an incline.

G. Winch clutch should be disengaged when winch is

not in use and fully engaged when in use.

H. Modification, alteration, or deviation to the winch

should only be made by Ramsey Winch Company.

I. Keep the duration of your pulls as short as possible.

If the motor becomes uncomfortably hot to the touch,

stop and let it cool for a few minutes. Do not pull

more than one minute at or near the rated load. Do

not maintain power to the winch if the motor stalls.

Electric winches are for intermittent usage and

should not be used in constant duty applications.

J. Disconnect the remote control switch from the winch

when not in use. A Ramsey Part No. 282053 safety

on-off switch in your vehicle is recommended.

K. Do Not use winch in hoisting applications due to

required hoist safety factors and features.

L. Do not exceed maximum line pull ratings shown in

tables. Shock loads must not exceed these ratings.

M. To respool correctly, it is necessary to keep a slight

load on the cable. This is accomplished by (wearing

gloves) holding the cable with one hand and the

remote control with the other, starting as far back and

in the center as you can, walking up keeping load on

the cable as the winch is powered in. Do not allow

the cable to slip through your hand and do not

approach the winch too closely. Turn off the winch

and repeat the procedure until all the cable except a

few feet is in. Disconnect the remote control switch

and finish spooling in cable by rotating the drum by

hand with clutch disengaged. On hidden winches,

spool in cable under power using supplied hook

strap.

Tips for Safe Operation

Don’t underestimate the potential danger in winching

operations. Neither should you fear them. Do learn the

basic dangers and avoid them.

Observe spooling of cable onto drum. Side pulls can

cause cable to pileup at one end of the drum. To correct

uneven stacking, spool out that section of the cable and

move it to the other end of the drum and continue

winching. Uneven spooling which causes cable pileup

can interfere with the tie bars causing damage to the

winch.

Store the remote control switch inside your vehicle where

it will not become damaged. Inspect it before you plug it

in.

When ready to begin spooling in, plug in remote control

switch with clutch disengaged. Do not engage clutch

with motor running.

Never connect the hook back to the cable. This causes

cable damage. Always use a sling or chain of suitable

strength, as shown in the illustration.

Observe your winch while winching, if possible, while

standing at a safe distance. If you use vehicle drive to

assist, stop and get out every few feet to assure the cable

is not piling up in one corner. Jamming cable can break

your winch.

Do not attach tow hooks to winch mounting apparatus.

They must attach to vehicle frame.

When double lining during stationary winching, the winch

hook should be attached to the chassis of the vehicle.

Since the greatest pulling power is achieved on the

innermost layer of your winch, it is desirable to pull off as

much line as you can for heavy pulls. If this is not

practical, use a snatch block and double line

arrangement (see illustration). Remember, a minimum of

5 wraps of cable around the drum barrel is necessary to

hold the rated load.

Neat, tight spooling avoids cable binding which is caused

when a load is applied and the cable is pinched betwen

two others. If this happens, alternately power the winch

in and out a few inches. Do not attempt to work a bound

cable under load, free by hand.

1 2 3 4 5 6 7 ... 11 12

Kommentare zu diesen Handbüchern

Keine Kommentare

Ramsey-winch PATRIOT 15000 Bedienungsanleitung Seite 2

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Für das Auto Ramsey-winch PATRIOT 15000