Ramsey-winch LEVEL WINDER 3 256078 Bedienungsanleitung PDF herunterladen

RAMSEY WINCH COMPANY * P.O. BOX 581510 * TULSA, OKLAHOMA 74158

KI-912544-1202-C

This Level Winder is designed specifically for the Ramsey Winch Model RPH-8000/RPH-10,000

& IPH-8000/IPH-10,000 Series Winches, with standard length drums. The RPH8 winch is 9.75

inches between drum flanges and the IPH8/IPH10 winch is 9.75 inches between drum flanges .

NOTE: IF LEVEL WINDER IS BEING INSTALLED ON A CAR CARRIER (ROLLBACK), IT IS

NECESSARY TO ALSO INSTALL RAMSEY ROLLER GUIDE KIT, PART NO. 256079.

FAILURE TO DO SO MAY CAUSE DAMAGE OR BREAKAGE TO THE WINCH LEVEL

WINDER OR VEHICLE.

INSTALLATION PROCEDURE

Disengage the winch clutch and free spool all the cable off the winch and lay it in a line on the

ground behind the truck. Disconnect the end of the cable from the cable drum anchor. Drill two

.562 diameter holes through the horizontal flange of the forward most winch mounting angle as

shown in FIG. 1.

Insert the spring retainer into the springs so that the cleats of the retainer will extend toward the

vehicle cab when the assembly is in place. Slide the retainer so that the holes in the retainer line

up with the hold down loops in the springs. Position the holes in the retainer over the .562

diameter holes previously drilled in the flange of the winch mounting angle. Loosely attach the

spring retainer and springs to the flange of the winch mounting angle using the 1/2 inch

diameter capscrews, nuts and lockwashers. Slide tensioner into position until half loops on ends

of springs snap into place over crossbar. Tighten capscrews securely, but do not torque. Use

rubber mallet to tap springs and spring retainer toward winch to the forward-most position,

making sure that cable tensioner is centered between the drum flanges, as shown in FIG. 2.

Tighten the capscrews securely so that the springs are clamped hard down onto their mounting

surface.

1 2

RAMSEY WINCH COMPANY * P.O. BOX 581510 * TULSA, OKLAHOMA 74158 KI-912544-1202-C This Level Winder is designed specifically for the Ramsey Winch Model

RAMSEY WINCH COMPANY * P.O. BOX 581510 * TULSA, OKLAHOMA 74158 KI-912544-1202-C NOTE: The surface to which the springs are bolted must be 1.25 +.50 i

Keine Kommentare

Ramsey-winch LEVEL WINDER 3 256078 Bedienungsanleitung