Ramsey-winch 16K Capstan Bedienungsanleitung

16K HYDRAULIC PLANETARY CAPSTAN DRIVE CAUTION: READ AND UNDERSTAND THIS MANUAL BEFORE INSTALLATION AND OPERATION OF CAPSTAN DRIVE. SEE WARNINGS!

Piston, backup piston, brake discs and stators must be clean and free of grease and oil. Set winch with gear housing end down on work surface. Install

Insert springs (item #18) into pockets in back of brake piston. Insert motor coupling (item #4) , engaging it with input shaft (item #5). Place gaske

103104101102DISASSEMBLY OF CARRIER ASSEMBLY Carrier assemblies may be purchased as a complete assembly (see pg.16 ) or parts may be purchased individu

11 Ø2.44Ø4.757.750.69Ø0.752.5524.8017.054.255.648.50VENT/FILL PORT7.167.163.583.588.504.258.504x Ø0.65LEVEL PORT(BOTH SIDES)DRAIN PORT3/4-10UNC-2B X 1

12 541522610254012914242336372122139191718273313201668734323351138202324302931222228

PARTS LIST 13 ITEM QTY PART NO DESCRIPTION ITEM QTY PART NO DESCRIPTION 1 1 338376 HOUSING-GEAR, MACHINED, 23 2 402130 BEARING-BAL

RAMSEY WINCH warrants each new RAMSEY Winch to be free from defects in material and workmanship for a period of one (1) year from date of purchase. Th

TABLE OF CONTENTS FORWORD...

RAMSEY HYDRAULIC PLANETARY CAPSTAN DRIVE 16K PLEASE READ THIS MANUAL CAREFULLY This manual contains useful ideas for obtaining the most efficient oper

2 CAPSTAN DRIVE MOUNTING CAPSTAN SAFEGUARDS AND OPERATION The capstan drive is equipped with a dual brake valve cartridge; therefore, the capstan may

HYDRAULIC SYSTEM REQUIREMENTS Refer to the performance charts below to properly match your hydraulic system to the capstan performance. The charts

CONDITIONS POSSIBLE CAUSE CORRECTION CAPSTAN WILL NOT PULL MAXIMUM LOAD 1. System relief valve may be set too low 2. Low Hydraulic Oil 1.

INSTRUCTIONS FOR OVERHAUL 16K CAPSTAN Take note of mounting configurations for proper mounting of parts during re-assembly. Replace all gaskets, o-rin

Remove retaining rings (items #27 and 35) with screwdriver. Remove brake parts from end bearing. NOTE POSITION OF O-RINGS AND BACKUP RINGS BEFORE REMO

Remove the carrier assembly (item #2), input coupling (item #10), and retaining ring (item #26). Remove ring gear (item #12) and dowel pins (item #15